Lightolier C7CW Manuel d'utilisateur télécharger pdf (Page 2)

FIG. 5

TO REPLACE BALLAST (Fig. 5 & 6)

Before changing the ballast, switch off the main power supply to the fixture.

STEP 1: Remove lamp.

STEP 2: Squeeze LAMPHOLDER SPRING while pushing

upward to disengage from REFLECTOR.

STEP 3: For cylinder with optional Auxiliary lighting, detach AUXILIARY

SSEMBLY SOCKET ASSEMBLY from REFLECTOR.

STEP 4: Remove WING NUTS, then separate UPPER HOUSING from top

of LOWER HOUSING to access BALLAST/PLATE ASSEMBLY.

STEP 5: Turn SCREW at SUPPORT BRACKET counterclockwise to loosen

SUPPORT BRACKET. Repeat with other (2) screws. Carefully remove

BALLAST/PLATE ASSEMBLY from UPPER HOUSING.

STEP 6: Replace BALLAST, capacitor and ignitor (magnetic type ballast).

STEP 7: Reattach BALLAST/PLATE ASSEMBLY to UPPER HOUSING by

tightening SCREWS until SUPPORT BRACKET locks onto UPPER

HOUSING. Repeat with other (2) screws.

STEP 9: Align STUDS with holes in LOWER HOUSING, then firmly tighten

with WING NUTS.

STEP 10: Reinstall REFLECTOR. For additional instructions (if needed),

see Reflector Trim Instruction Sheet.

A COMPANY

631 Airport Road, Fall River, MA 02720

READ AND UNDERSTAND THESE INSTRUCTIONS BEFORE INSTALLING FIXTURE

This fixture is intended for installation in accordance with the National Electrical Code and local regulations. To

assure full compliance with local codes and regulations, check with your local electrical inspector before

installation. To prevent electric shock, turn off electricity at fuse box before proceeding.

Retain these

instructions for maintenance reference.

INSTRUCTION SHEET NO.

IS:C7CW

Page 2 of 2

A0604

WARNING: USE ONLY REFLECTOR TRIMS PROVIDED BY LIGHTOLIER. USE OF OTHER MANUFACTURERS’

REFLECTOR TRIMS MAY VOID THE UNDERWRITERS LABORATORIES LISTING AND COULD CONSTITUTE A FIRE HAZARD.

INSTALLATION PROCEDURE FOR: C7CW SERIES 7” DIA. H.I.D. WALL CYLINDER

USED WITH C7E17VM, C7E17OVM, C7P38MH, C7E17PL, C7E17FL SERIES FLANGLESS

REFLECTOR TRIM (ORDER SEPARATELY)

1 2

Pas de commentaire

Lightolier C7CW Manuel d'utilisateur Page 2