Lightolier IS:9060 Manuel d'utilisateur télécharger pdf

INSTRUCTION SHEET NO.

IS:9060

A0497 Page 1 of 1

READ AND UNDERSTAND THESE INSTRUCTIONS BEFORE INSTALLING FIXTURE

This fixture is intended for installation in accordance with the National Electrical Code and local regulations.

To assure full compliance with local codes and regulations, check with your local electrical inspector before

installation. To prevent electrical shock, turn off electricity at fuse box before proceeding.

Retain these instructions for maintenance reference.

JUNCTION BOX COVER FOR USE WITH

9100 SERIES, RADIUS

TRACK SYSTEMS ONLY

CAUTION:

• TURN OFF POWER AT FUSE BOX BEFORE INSTALLING TRACK.

• INSTRUCTIONS FOR GROUNDING MUST BE FOLLOWED.

FAILURE TO DO SO MAY RESULT IN AN ELECTRICAL HAZARD.

• USE SOLID 12 OR 14 GA. WIRES FOR SUPPLY TO TRACK (NOT STRANDED).

• OBSERVE POLARITY, WHITE SUPPLY LEAD (NEUTRAL) TO TERMINAL MARKED “NEUT”.

FALL RIVER, MASSACHUSETTS 02720

MONTREAL, QUEBEC, CANADA

1. Mark centerline of track location through center of J-BOX.

Remove BOTTOM COVER from CONNECTOR.

2. Remove KNOCK OUT from TOP PLATE (Fig. 4)

3. Place CANOPY SPACER (Fig. 3) on TOP PLATE (Fig. 4).

4. Line up CROSSBAR (Fig. 2) with the TABS on the CANOPY SPACER.

Mount CROSSBAR to CONNECTOR (Fig. 4) with SCREW. Connect

GROUND WIRE (Fig. 2) to GROUNDING TERMINAL in J-BOX. Pass

SUPPLY LEADS from OUTLET BOX through CROSSBAR center

hole and KNOCKOUT hole in CONNECTOR.

5. Mount track to ceiling as shown in track Instruction Sheet

IS:9100. Secure the CROSSBAR to the J-BOX using the two

J-BOX SPECIAL SCREWS included (Fig. 2).

6. Slide the CANOPY between the CROSSBAR and CONNECTOR.

Optional:

a. Drill two 5/32” diameter holes in CANOPY DIMPLES.

b. Slide the CANOPY between the CROSSBAR and CONNECTOR.

c. Secure with COVER MOUNTING SCREWS. (Fig. 5)

7. Connect SUPPLY LEADS to TERMINALS in CONNECTOR as

shown in Instruction Sheet IS:9155.

The Junction Box Cover mounts to a Radius 9147WH, BK; 9151WH, BK; 9155WH, BK Connector for feed from an outlet box.

FIG. 3

CEILING

FIG. 4

IG. 2

IG. 1

IG. 5

CONNECTOR

BOTTOM COVER

3” OR 4” OCTAGONAL

J-BO X ( by others )

SCREW (1)

TOP PLATE

CONNECTOR

CANOPY SPACER

CROSSBAR

COVER MOUNTING SCREW (2)

(optional)

CANOPY

DIMPLES

KNOCK OUT ( removed )

GROUND WIRE

J-BO X SCREW (2) SPECIAL

Résumé du contenu

Page 1 - TRACK SYSTEMS ONLY

INSTRUCTION SHEET NO.IS:9060A0497 Page 1 of 1READ AND UNDERSTAND THESE INSTRUCTIONS BEFORE INSTALLING FIXTUREThis fixture is intended for install

Commentaires sur ces manuels

Pas de commentaire

Lightolier IS:9060 Manuel d'utilisateur

Naviguer en ligne ou télécharger Manuel d'utilisateur pour Non Lightolier IS:9060. Lightolier IS:9060 User's Manual [en] [fr] Manuel d'utilisatio

Résumé du contenu

Commentaires sur ces manuels

Produits connexes et manuels pour Non Lightolier IS:9060