Lightolier CA3FMR Manuel d'utilisateur télécharger pdf

U.S. AND FOREIGN PATENTS PENDING

PLASTER

SHIELD

PLASTER/JOINT

COMPOUND

NOTE: Photos shown here assume the Frame-In Kit

and ceiling are already installed.

For flangeless installations, cardboard PAINT

OVERSPRAY SHIELD, which is installed in 3”

Evolution Frame-In-Kits, must be removed prior to

CA3FMR installation.

NOTE: The bottom surface of the Frame-In Kit should be

flush with the top surface of the ceiling material.

1. Do not remove cardboard FLANGELESS TRIM RING

PLASTER SHIELD from flangeless trim ring.

2. Prior to installation, ensure that ceiling opening is

3-5/8” in diameter.

NOTE: For maximum adhesion, a bead of construction

adhesive can be applied to the back (ceiling) side of the

FLANGELESS TRIM RING perforated flange.

3. Insert FLANGELESS TRIM RING into ceiling opening

and rotate clockwise, ensuring the perforated flange is

flush to the ceiling (Fig. 1). Blades on outside edge of

ring should bite into ceiling and secure ring in place.

NOTE: For applications where ceiling thickness is less

than ¾”, FLANGELESS TRIM RING should fit between

ceiling & Frame-In Kit (Fig 2). For applications where

ceiling thickness exceeds ¾”, FLANGELESS TRIM RING

will not contact installed Frame-In Kit. It is therefore

critical that FLANGELESS TRIM RING be vertically

aligned with the Frame-In Kit aperture. Vertical walls of

cardboard FLANGELESS TRIM RING PLASTER

SHIELD should fit inside Frame-In Kit aperture and be

used to ensure vertical alignment.

READ AND UNDERSTAND THESE INSTRUCTIONS BEFORE INSTALLING LUMINAIRE

This luminaire is intended for installation in accordance with the National Electrical Code and local regulations.

To assure full compliance with local codes and regulations, check with your local electrical inspector before

installation. To prevent electric shock, turn off electricity at fuse box before proceeding.

Retain these instructions for maintenance reference.

INSTALLATION PROCEDURE FOR CALCULITE® EVOLUTION:

CA3FMR SERIES FLANGELESS TRIM RING FOR FLANGELESS TRIMS

INSTRUCTION SHEET NO.

IS: CA3FMR

A1104

Page 1 of 2

A COMPANY

631 Airport Road, Fall River, MA 02720

Fig. 1

CEILING

INSTALL RING IN

THIS DIRECTION

FLANGELESS TRIM

RING PERFORATED

FLANGE

. 2 FRAME-IN KIT

CEILING

CA3FMR FLANGELESS

TRIM RING

CEILING

OPENING

VERTICAL

WALLS

3-5/8”

OPENING

1 2

IS: CA3FMR 1

Résumé du contenu

Page 1 - IS: CA3FMR

U.S. AND FOREIGN PATENTS PENDING PLASTER SHIELD PLASTER/JOINT COMPOUND NOTE: Photos

Page 2

U.S. AND FOREIGN PATENTS PENDINGCEILING APPEARANCE AFTER PLASTER / COMPOUND HAS BEEN APPLIED AND FLANGELESS TRIM R

Commentaires sur ces manuels

Pas de commentaire

Lightolier CA3FMR Manuel d'utilisateur

Naviguer en ligne ou télécharger Manuel d'utilisateur pour Non Lightolier CA3FMR. Lightolier CA3FMR User's Manual Manuel d'utilisatio

Résumé du contenu

Commentaires sur ces manuels

Produits connexes et manuels pour Non Lightolier CA3FMR